The complete cell phone jammer intelligent management system mainlyconsists of cell phone signal detector

2.2.2 Run the software installed in the computer and read all detecting IP addresses one by one and allocate the relevant information. (The only IP address code has been read for every detector before delivery; mark the building number, floor number and room number for every address code when reading every address code).

Connect the power supply DC to the host and insert the AC input end of the power supply adapter.

City electricity socket and switch on power supply of host. mobile phone jammer (power supply of the detector should be selected and matched according to the program).

2.2 Adjust CDMA (800MHz) at first: clockwise adjust the potentiometer until the red light flashes while observing the indication light. And then adjust 5 degree back and shut off power supply switch for once. At this time, the green light should flash. If the red light is still on at this time, the potentiometer should be adjusted back a little bit more and the power supply switch of cell phone jammer system should be turned off for once until the green light flashesThe complete cell phone jammer intelligent management system mainly consists of cell phone signal detector (abbreviated as the detector hereafter), numerical control box (abbreviated as the NC box hereafter), cell phone jammer (abbreviated as the jammer hereafter) and computer. But the corresponding components and functions can be selected according to requirements of different customers